Quick Finder

Testimonials

Dr Gary Lawrence, Dublin City University

WPI are my preferred supplier for tissue and cell recording instrumentation. In my experience, WPI representatives have an excellent level of technical expertise and they have always responded in a timely manner with the most helpful, patient and instructive advice to aid the development of the o...
read more

Home > Products > Animal Physiology > Stereotaxic Instruments > Premium Stereotaxic Instruments > Adaptors and Accessories > Holders and components

Holders and components

505247

Drill Holder for OmniDrill. The Drill Holders were designed specifically for the Micromotor Drills

505248

Drill Holder, Micromotor Hi-Speed Drill

505249

Standard Probe Holder-Corner Clamp: Standard Probe Holders include an 11mm square acrylic block connected to our standard 19.5cm standard shaft (6mm diameter) with grooves spaced 1 mm apart. The grooves (on three sides) facilitate loading of probes.

505250

Standard Probe Holder - Side Clamp: Standard Probe Holders include an 11mm square acrylic block connected to our standard 19.5cm standard shaft (6mm diameter) with grooves spaced 1 mm apart. The grooves (on three sides) facilitate loading of probes.

505251

Large Probe Holder. The Large Probe Holder supports shafts with diameters from 6.5 mm up to 13 mm (0.5 inch). This holder is ideal for Hamilton™ Micro-syringes . A threaded drive pulls the sliding “U” holder against the outside of the probe, pulling the probe into a “V” notch for straight and reproducible positioning.

505252

Electrode Holder, `C' Clamp

505253

Cannula and Minipump Holder: The Cannula Holder was designed to hold 3.4 mm cannula heads, as manufactured by Plastics One™ for cannula sets, and DURECT for ALZET® Osmotic Pumps. Non-intrusive for cementing cannulas in place

The 505253 holds the cannula vertically directly in line with the shaft of the probe holder

505254

Cannula Holder: Cannula Holder was designed to hold 3.4 mm cannula heads, as manufactured by Plastics One™ for cannula sets, and DURECT for ALZET® Osmotic Pumps. Non-intrusive for cementing cannulas in place

The 505254 holds the cannula away from the shaft of the probe holder while the 505253 holds the cannula vertically directly in line with the shaft of the probe holder

505255

Cannula Holder for CMA 7, 11 & 12 Guide

505256

Microdialysis Probe Holder: Customized to fit a specific size of probe. The hole may be drilled to fit probes from 1.5 to 6.0 mm. Default size is 1.5 mm

505257

Dual Large Probe Holder: Double-Head Large Probe Holder has a large ”C” gripping component at each end, with the “V” clamp attachment. Clamps ¼"–½" diameter.